Bosch Appliances 8-Dec Home Security System User Manual


 
208 | Detectors and Accessories | Motion Long Range
Top View
Standard Long Range: 61 m x 3 m (200 ft x 10 ft)
Side View
Standard Long Range: 61 m x 3 m (200 ft x 10 ft)
Top View
Optional Long Range 37 m x 8 m (120 ft x 26 ft)
Side View
Optional Long Range 37 m x 8 m (120 ft x 26 ft)
Standby Power
If there is no internal standby battery, connect to DC power
source capable of supplying standby power if the primary
power fails.
Model Standby Power mAh required per hour
DS794Z No standby battery 18 mAh
DS794ZE No standby battery 25 mAh
DS794ZE-FRA No standby battery 18 mAh
ZX794Z Provided by the Zonex
bus
0.5 mAh
Note A minimum of four hours of standby power is
required for UL Listed requirements.
Parts Included
For your convenience, the OA200 Mirror and OA80 Mirror
are included with the detector.
Technical Specifications
Enclosure
Dimensions: 14 cm x 21 cm x 14 cm
(5 in. x 7.5 in. x 5 in.)
Material: High impact ABS plastic enclosure
Environmental Considerations
Operating Tem-
perature:
-29°C to +49°C (-20°F to +120°F)
For UL Certificated installations, 0°C to +49°C (+32°F to
+120°F)
Radio Frequency
Interference
(RFI) Immunity:
No alarm or setup on critical frequencies in the range
from 26 MHz to 950 MHz at 50 V/m.
DS794ZE: Complies with Environmental Class II (EN50130-5)
Mounting
Height: 5 m (15 ft.) maximum
Location: Surface or corner
Power Requirements
Current Draw: 18 mA at 12 VDC
25 mA at 12 VDC (DS794ZE)
Voltage (Input): 6 VDC to 15 VDC
ZX794Z: Power comes from two-wire Zonex Bus.
<0.5 mA nominal, 2 mA in alarm with LEDs enabled.
Do not leave Walk Test LEDs enabled.
Outputs
Alarm: ZX794Z: Signal through POPIT data bus.
DS794ZE-FRA: Form C Contacts rated at 3.0 W, 125 mA at
28 VDC for resistive loads protected by a 4.7 Ω resistor in the
common C leg.
Tamper: Normally-closed (with cover in place). Contacts rated at
28 VDC, 125 mA maximum.
ZX794Z: Signal through POPIT data bus. Signaled as Missing.
Trouble: Solid state output, shorts to negative when activated. Maxi-
mum current load is 25 mA.
ZX794Z: Signal through POPIT data bus.
Trademarks
Sonalert
®
is a registered trademark of Mallory Sonalert
®
Products, Inc.
Ordering Information
DS794Z Long‑Range PIR Intrusion Detector
Provides Motion Analyzer II processing, Motion
Monitor, and three coverage patterns, and
61 m x 3 m (200 ft x 10 ft) long range coverage.
DS794Z
DS794ZE‑FRA Long‑Range PIR Intrusion
Detector
For use in France. Provides Motion Analyzer II
processing, Motion Monitor, and three cover-
age patterns, and 61 m x 3 m (200 ft x 10 ft)
long range coverage.
DS794ZE-FRA
Accessories
OA120‑2 Mirror
A 36.5 m (120 ft) optical array module. Ship-
ped in packages of two.
OA120-2
Bosch Security Systems B.V. www.boschsecurity.com
5