Detectors and Accessories | Magnetic Contacts Surface Mount | 285
AMK 4 S Z Shutter Door
Contact
Features
▶
Shutter door contact in conventional technology
▶
For connection to the conventional intrusion control
panel
▶
VdS class C
▶
Tamper switch
▶
High level of mechanical strength
▶
Large switch distance
▶
Conventional perimeter protection
Conventional shutter door contacts are used to monitor
shutter, sliding and garage doors.
Certifications and Approvals
Region Certification
Europe CE AMK 4 SZ
Germany VdS G 191021, C AMK 4 S
Installation/Configuration Notes
Installation notes
•
For doors < 1.5 m, one shutter door contact is required.
For doors > 1.5 m, use two shutter door contacts. Take
note of the permissible installation tolerances.
•
The shutter door contact consists of a sealed magnetic
switch and a magnet in a plastic casing.
•
The connection cable is protected over 1 m by a metal
tube.
•
The magnetic switch is installed at ground level
(requires a flat surface). Vehicles with rubber tires can
drive over the switch without causing problems. In spite
of this, the magnetic switch must not be used as a door-
stopper.
•
The supply lines need to be measured electrically
before connection.
Distances diagram
1 Extraction
2 Proximity switch part
3 Standby zone
4 Tamper zone
Parts Included
Type Qty. Component
AMK 4 S Z 1 Shutter door contact incl. magnet and in-
stallation material and cable
Technical Specifications
Type of installation Surface mount
Permissible operating voltage Max. 40 V_
Contact type 1-pin (normally) open contact
Maximum loop rating 6 VA
Max. 100 V_
Max. 500 mA
Protection category IP 67, VdS environmental class IV
Permissible ambient temperature -25 °C to +70 °C
Housing
•
Material
Polyamide GF
•
Color
Gray
Dimensions
•
Contact (H x W x L)
50 x 16.5 x 144 mm
•
Magnet (H x W x D)
40 x 35 x 66 mm
•
Connection cable (Ø x L)
3.2 mm x 6 m
www.boschsecurity.com Bosch Security Systems B.V.
5
