Filter
Top Products
port storm-control include-multicast (IC) 95
User Guidelines
To control multicasts storms, use the port storm-control broadcast
enable and port storm-control broadcast rate commands.
Example
The following example enables counting multicast packets.
port storm-control
include-multicast
(IC)
The port storm-control include-multicast Interface Configuration
(Ethernet) mode command counts multicast packets in broadcast storm
control. To disable counting multicast packets, use the no form of this
command.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
■ unknown-unicast — Specifies also counting unknown unicast
packets.
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Console#
configure
Console(config-if)#
port storm-control include-multicast
Console(config-if)# port storm-control iinclude-multicast
unknown-unicast