Filter
Top Products
158 CHAPTER 10: CLOCK COMMANDS
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface Configuration (Ethernet, port-channel, VLAN) mode
User Guidelines
Use the sntp anycast client enable Global Configuration mode
command to enable anycast clients globally.
Example
The following example enables the SNTP client on Ethernet port g3.
sntp unicast client
enable
The sntp unicast client enable Global Configuration mode command
enables the device to use the Simple Network Time Protocol (SNTP) to
request and accept SNTP traffic from servers. To disable requesting and
accepting SNTP traffic from servers, use the no form of this command.
Syntax
sntp unicast client enable
no sntp unicast client enable
Default Configuration
The SNTP unicast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the sntp server Global Configuration mode command to define
SNTP servers.
Console(config)#
interface ethernet
g3
Console(config-if)#
sntp client enable