Filter
Top Products
wlan station idle-timeout 507
Parameters
■ db — Specifies the signal loss, in dB. (Range: 20-80 dB)
Default Configuration
The default minimum signal loss difference is 60 dB.
Command Mode
Global Configuration mode
User Guidelines
The Auto Transmit Power algorithm adjusts AP power due to another AP
which is very close, because it is impossible to avoid interference in that
case and the APs will have essentially the same coverage zone. The
minimum signal loss is the signal strength difference (transmitted -
received) below which two radios are considered too close.
Example
The following example configures the minimum signal loss difference to
30 dB.
wlan station
idle-timeout
The wlan station idle-timeout Global Configuration mode command
configures the length of time before an idle station is removed from the
system and required to login. To restore defaults, use the no form of this
command.
Syntax
wlan station idle-timeout minutes
no wlan station idle-timeout
Parameters
■ minutes — Specifies the IDLE timeout in minutes. (Range: 3-1440)
Default Configuration
The default timeout is 30 minutes.
Console (config)#
wlan tx-power auto signal-loss
30