Filter
Top Products
56 CHAPTER 4: ADDRESS TABLE COMMANDS
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Using the no form of the command without specifying a MAC address
deletes all static MAC addresses belonging to this VLAN).
Example
The following example adds a permanent static MAC-layer station source
address 3aa2.64b3.a245 on port 1 to the bridge table.
bridge multicast
filtering
The bridge multicast filtering Global Configuration mode command
enables filtering multicast addresses. To disable filtering multicast
addresses, use the no form of this command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Filtering multicast addresses is disabled. All multicast addresses are
flooded to all ports.
Command Mode
Global Configuration mode
User Guidelines
If multicast devices exist on the VLAN, do not change the unregistered
multicast addresses state to drop on the switch ports.
Console(config)#
interface vlan
2
Console(config-if)#
bridge address
3aa2.64b3.a245
ethernet
g16
permanent