Filter
Top Products
280 CHAPTER 18: PORT MONITOR COMMANDS
GVRP is not enabled on the port.
The port is not a member of a VLAN, except for the default VLAN (will
automatically be removed from the default VLAN).
The following restrictions apply to ports configured to be source ports:
The port cannot be already configured as a destination port.
Maximum number of source ports can be up to eight.
Example
The following example copies traffic for both directions (Tx and Rx) on port
g8 (source port) to port 1 (destination port).
show ports monitor The show ports monitor Privileged EXEC mode command displays the
port monitoring status.
Syntax
show ports monitor
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how the port monitoring status is
displayed.
Console(config)#
interface ethernet
g1
Console(config-if)#
port monitor
g8
Console#
show ports monitor
Source
Port
Destinatio
n Port
Type Status