Filter
Top Products
82 CHAPTER 5: ETHERNET CONFIGURATION COMMANDS
Syntax
negotiation [capability1 [capability2…capability5]]
no negotiation
Parameters
■ capability — Specifies the capabilities to advertise. (Possible values:
10h, 10f, 100h,100f, 1000f)
Default Configuration
Auto-negotiation is enabled.
If unspecified, the default setting is to enable all capabilities of the port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If capabilities were specified when auto-negotiation was previously
entered, not specifying capabilities when currently entering
auto-negotiation overrides the previous configuration and enables all
capabilities.
Example
The following example enables auto-negotiation on Ethernet port 1.
flowcontrol The flowcontrol Interface Configuration (Ethernet, port-channel) mode
command configures flow control on a given interface. To disable flow
control, use the no form of this command.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Console(config)#
interface ethernet
1
Console(config-if)#
negotiation