Filter
Top Products
set 125
Example
The following example configures the trust state for a class called ‘class1’
in a policy map called ‘policy1’.
set The set Policy-map Class Configuration mode command sets new values
in the IP packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos}
no set
Parameters
■ new-dscp — Specifies a new DSCP value for the classified traffic.
(Range: 0-63)
■ queue-id — Specifies an explicit queue ID for setting the egress
queue.
■ new-cos — Specifies a new user priority for marking the packet.
(Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
This command is mutually exclusive with the trust Policy-map Class
Configuration command within the same policy map.
Policy maps that contain set or trust Policy-map Class Configuration
commands or that have ACL classifications cannot be attached to an
egress interface by using the service-policy (Ethernet, Port-channel)
Interface Configuration mode command.
Console (config)# policy-map policy1
Console (config-pmap)# class class1
Console (config-pmap-c)# trust cos dscp