Filter
Top Products
446 CHAPTER 32: GVRP COMMANDS
gvrp enable
(Interface)
The gvrp enable Interface Configuration (Ethernet, port-channel) mode
command enables GVRP on an interface. To disable GVRP on an
interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port does not dynamically join a VLAN because it is always a
member in only one VLAN.
Membership in an untagged VLAN is propagated in the same way as in a
tagged VLAN. That is, the PVID is manually defined as the untagged
VLAN VID.
Example
The following example enables GVRP on Ethernet port g6.
garp timer The garp timer Interface Configuration (Ethernet, Port channel) mode
command adjusts the values of the join, leave and leaveall timers of GARP
applications. To restore the default configuration, use the no form of this
command.
Console(config)#
interface ethernet g
6
Console(config-if)#
gvrp enable