Filter
Top Products
bridge multicast forward-all 59
Parameters
■ add — Adds ports to the group.
■ remove — Removes ports from the group.
■ mac-multicast-address — A valid MAC multicast address.
■ ip- multicast-address — A valid IP multicast address.
■ interface-list — Separate nonconsecutive Ethernet ports with a
comma and no spaces; hyphen is used to designate a range of ports.
■ port-channel-number-list — Separate nonconsecutive valid
port-channels with a comma and no spaces; a hyphen is used to
designate a range of port-channels.
Default Configuration
No forbidden addresses are defined.
Command Modes
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the multicast group should be
registered.
Example
In this example, MAC address 0100.5e02.0203 is forbidden on port g9
within VLAN 8.
bridge multicast
forward-all
The bridge multicast forward-all Interface Configuration (VLAN) mode
command enables forwarding all multicast packets on a port. To restore
the default configuration, use the no form of this command.
Console(config)#
interface vlan
8
Console(config-if)#
bridge multicast address
0100.5e.02.0203
Console(config-if)#
bridge multicast forbidden address
0100.5e02.0203
add ethernet g
9