Filter
Top Products
spanning-tree priority 213
Example
The following example configures the spanning tree bridge
maximum-age to 10 seconds.
spanning-tree
priority
The spanning-tree priority Global Configuration mode command
configures the spanning tree priority of the device. The priority value is
used to determine which bridge is elected as the root bridge. To restore
the default configuration, use the no form of this command.
Syntax
spanning-tree priority priority
no spanning-tree priority
Parameters
■ priority — Priority of the bridge. (Range: 0-61440 in steps of 4096)
Default Configuration
The default bridge priority for IEEE Spanning Tree Protocol (STP) is 32768.
Command Modes
Global Configuration mode
User Guidelines
The bridge with the lowest priority is elected as the root bridge.
Example
The following example configures spanning tree priority to 12288.
spanning-tree
disable
The spanning-tree disable Interface Configuration mode command
disables spanning tree on a specific port. To enable spanning tree on a
port, use the no form of this command.
Console(config)# spanning-tree max-age 10
Console(config)# spanning-tree priority 12288