Filter
Top Products
478 CHAPTER 34: 802.1X COMMANDS
The timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout
server-timeout value and the result of multiplying the radius-server
retransmit value with the radius-server timeout value and selecting
the lower of the two values.
Example
The following example sets the time for the retransmission of packets to
the authentication server to 3600 seconds.
show dot1x The show dot1x Privileged EXEC mode command displays the 802.1x
status of the device or specified interface.
Syntax
show dot1x [ethernet interface]
Parameters
■ interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
Console(config)# interface ethernet g16
Console(config-if)#
dot1x timeout server-timeout
3600