Filter
Top Products
dot1x single-host-violation 487
dot1x
single-host-violatio
n
The dot1x single-host-violation Interface Configuration mode
command configures the action to be taken, when a station whose MAC
address is not the supplicant MAC address, attempts to access the
interface. Use the no form of this command to restore defaults.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown}
[trap seconds]
no port dot1x single-host-violation
Parameters
■ forward — Forwards frames with source addresses that are not the
supplicant address, but does not learn the source addresses.
■ discard — Discards frames with source addresses that are not the
supplicant address.
■ discard-shutdown — Discards frames with source addresses that are
not the supplicant address. The port is also shut down.
■ trap — Indicates that SNMP traps are sent.
■ seconds — Specifies the minimum amount of time in seconds
between consecutive traps.
(Range: 1- 1000000)
Default Configuration
Frames with source addresses that are not the supplicant address are
discarded.
No traps are sent.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command is relevant when multiple hosts is disabled and the user
has been successfully authenticated.