Filter
Top Products
4
ADDRESS TABLE COMMANDS
bridge address The bridge address Interface Configuration (VLAN) mode command
adds a MAC-layer station source address to the bridge table. To delete
the MAC address, use the no form of this command.
Syntax
bridge address mac-address {ethernet interface | port-channel
port-channel-number} [permanent | delete-on-reset |
delete-on-timeout | secure]
no bridge address [mac-address]
Parameters
■ mac-address — A valid MAC address.
■ interface — A valid Ethernet port.
■ port-channel-number — A valid port-channel number.
■ permanent — The address can only be deleted by the no bridge
address command.
■ delete-on-reset — The address is deleted after reset.
■ delete-on-timeout — The address is deleted after "age out" time
has expired.
■ secure — The address is deleted after the port changes mode to
unlock learning (no port security command). This parameter is only
available when the port is in the learning locked mode.
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent.