Filter
Top Products
mdix 83
Parameters
■ auto — Indicates auto-negotiation
■ on — Enables flow control.
■ off — Disables flow control.
Default Configuration
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Negotiation should be enabled for flow control auto.
Example
In the following example, flow control is enabled on port 1.
mdix The mdix Interface Configuration (Ethernet) mode command enables
cable crossover on a given interface. To disable cable crossover, use the
no form of this command.
Syntax
mdix {on | auto}
no mdix
Parameters
■ on — Manual mdix is enabled.
■ auto — Automatic mdi/mdix is enabled.
Default Configuration
The default setting is on.
Command Mode
Interface Configuration (Ethernet) mode
Console(config)#
interface ethernet
1
Console(config-if)#
flowcontrol on