Filter
Top Products
476 CHAPTER 34: 802.1X COMMANDS
process. To restore the default configuration, use the no form of this
command.
Syntax
dot1x max-req count
no dot1x max-req
Parameters
■ count — Number of times that the device sends an
EAP-request/identity frame before restarting the authentication
process. (Range: 1-10)
Default Configuration
The default number of times is 2.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients. and authentication servers
Example
The following example sets the number of times that the device sends an
EAP-request/identity frame to 6.
dot1x timeout
supp-timeout
The dot1x timeout supp-timeout Interface Configuration mode
command sets the time for the retransmission of an Extensible
Authentication Protocol (EAP)-request frame to the client. To restore the
default configuration, use the no form of this command.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Console(config)#
interface ethernet
g16
Console(config-if)#
dot1x max-req
6