Filter
Top Products
20
IP ADDRESS COMMANDS
ip address The ip address Interface Configuration (default VLAN) mode command
sets an IP address. To remove an IP address, use the no form of this
command.
Syntax
ip address ip-address {mask | prefix-length}
no ip address ip-address
Parameters
■ ip-address — Specifies the valid IP address.
■ mask — Specifies the valid network mask of the IP address.
■ prefix-length — Specifies the number of bits that comprise the IP
address prefix. The prefix length must be preceded by a forward slash
(/). (Range: 8-30)
Default Configuration
No IP address is defined for interfaces.
Command Mode
Interface Configuration (default VLAN) mode
User Guidelines
Only the default VLAN get be assigned an IP address.
An IP address cannot be configured for a range of interfaces (range
context).
This command is only functional if the device is in Switch mode.