Filter
Top Products
294 CHAPTER 19: SNMP COMMANDS
User Guidelines
When configuring an SNMPv1 or SNMPv2 notification recipient, a
notification view for that recipient is automatically generated for all the
MIB.
When configuring an SNMPv1 notification recipient, the Inform option
cannot be selected.
If a trap and inform are defined on the same target, and an inform was
sent, the trap is not sent.
Example
The following example enables SNMP traps for host 10.1.1.1 with
community string "management" using SNMPv2.
snmp-server
v3-host
The snmp-server v3-host Global Configuration mode command
specifies the recipient of Simple Network Management Protocol Version 3
notifications. To remove the specified host, use the no form of this
command.
Syntax
snmp-server v3-host {ip-address | hostname} username [traps |
informs] {noauth | auth | priv} [udp-port port] [filter filtername]
[timeout seconds] [retries retries]
no snmp-server host {ip-address | hostname} username [traps |
informs]
Parameters
■ ip-address — Specifies the IP address of the host (targeted recipient).
■ hostname — Specifies the name of the host. (Range:1-158 characters)
■ username — Specifies the name of the user to use to generate the
notification. (Range: 1-24)
■ traps — Indicates that SNMP traps are sent to this host.
■ informs — Indicates that SNMP informs are sent to this host.
■ noauth — Indicates no authentication of a packet.
■ auth — Indicates authentication of a packet without encrypting it.
Console(config)# snmp-server host 10.1.1.1 management 2