Filter
Top Products
radius-server timeout 275
Example
The following example configures the source IP address used for
communication with all RADIUS servers to 10.1.1.1.
radius-server
timeout
The radius-server timeout Global Configuration mode command sets
the interval during which the device waits for a server host to reply. To
restore the default configuration, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
Parameters
■ timeout — Specifies the timeout value in seconds. (Range: 1-30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval on all RADIUS
servers to 5 seconds.
radius-server
deadtime
The radius-server deadtime Global Configuration mode command
improves RADIUS response time when servers are unavailable. The
command is used to cause the unavailable servers to be skipped. To
restore the default configuration, use the no form of this command.
console(config)# radius-server source-ip 10.1.1.1
Console(config)# radius-server timeout 5