Filter
Top Products
tunnel priority 355
tunnel priority The tunnel priority AP Configuration mode command configures a
wireless AP priority for VLAN tunneling. To restore default settings, use
the no form of this command.
Syntax
tunnel priority priority
no priority
Parameters
■ priority — The relative priority of the wireless AP as a source for
VLANs. The number 0 indicates that the AP cannot be a source for
VLANs. (Range: 0-99)
Default Configuration
The default wireless AP priority for VLAN tunneling is 20.
Command Mode
AP Configuration mode
User Guidelines
If one of the stations that are associated with an AP is associated with a
VLAN that the AP does not have a direct connection to, the AP initiates a
tunnel with the AP that has a direct connection to that VLAN. The AP
with the highest tunneling priority in the network is chosen as the source
of the VLAN.
Example
The following example configures a wireless AP priority for VLAN
tunneling to 30.
wan enable The wan enable AP configuration mode command accommodates
certain timing constrains in the communication to a remotely connected
wireless AP separated by a WAN link or the Internet. To disable WAN
support, use the no form of this command.
Console (Config)# wlan ap CR1 config
Console (Config-ap)#
tunnel priority
30