Filter
Top Products
Layer 3 on the other node. Configuration mismatches are logged in the syslog and display in the show
vlt mismatch command output.
If you enable VLT unicast routing, the following actions occur:
• L3 routing is enabled on any new IP or IPv6 address configured for a VLAN interface that is up.
• L3 routing is enabled on any VLAN with an admin state of up.
NOTE: If the CAM is full, do not enable peer-routing.
NOTE: The peer-routing and peer-routing-timeout commands are supported on both IPv4
and IPv6 to enable L3 VLT peer routing and configure the delay after which peer routing is disabled.
Configuring VLT Unicast
To enable and configure VLT unicast, follow these steps.
1. Enable VLT on a switch, then configure a VLT domain and enter VLT-domain configuration mode.
CONFIGURATION mode
vlt domain domain-id
2. Enable peer-routing.
VLT DOMAIN mode
peer-routing
3. Configure the peer-routing timeout.
VLT DOMAIN mode
peer-routing—timeout value
value: Specify a value (in seconds) from 1 to 65535.
VLT Multicast Routing
VLT Multicast Routing provides resiliency to multicast routed traffic during the multicast routing protocol
convergence period after a VLT link or VLT peer fails using the least intrusive method (PIM) and does not
alter current protocol behavior.
Unlike VLT Unicast Routing, a normal multicast routing protocol does not exchange multicast routes
between VLT peers. When you enable VLT Multicast Routing, the multicast routing table is synced
between the VLT peers. Only multicast routes configured with a Spanned VLAN IP as their IIF are synced
between VLT peers. For multicast routes with a Spanned VLAN IIF, only OIFs configured with a Spanned
VLAN IP interface are synced between VLT peers.
The advantages of syncing the multicast routes between VLT peers are:
• VLT resiliency — After a VLT link or peer failure, if the traffic hashes to the VLT peer, the traffic
continues to be routed using multicast until the PIM protocol detects the failure and adjusts the
multicast distribution tree.
• Optimal routing — The VLT peer that receives the incoming traffic can directly route traffic to all
downstream routers connected on VLT ports.
• Optimal VLTi forwarding — Only one copy of the incoming multicast traffic is sent on the VLTi for
routing or forwarding to any orphan ports, rather than forwarding all the routed copies.
954
Virtual Link Trunking (VLT)