Filter
Top Products
Use the following command in CONFIGURATION mode:
Command Syntax Command Mode Purpose
ip redirect-list redirect-list-
name
CONFIGURATION Create a redirect list by entering the list name.
Format: 16 characters
Delete the redirect list with the no ip redirect-list command.
The following example creates a redirect list by the name of “xyz.”
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect
list. You can enter the command multiple times and create a sequence of redirect rules. Use the seq nn
redirect version of the command to organize your rules.
Command Syntax Command Mode Purpose
seq {number} redirect {ip-
address | tunnel tunnel-id}
[track <obj-id>}{ip-
protocol-number |
protocol-type [bit]} {source
mask | any | hostip-
address}{destination mask |
any | hostip-address}
CONF-REDIRECT-LIST Configure a rule for the redirect list.
number is the number in sequence to initiate this
rule
ip-address is the Forwarding router’s address
unnel is used to configure the tunnel settings.
tunnel-id is used to redirect the traffic.
track <obj-id> is used to track the object-id.
track is to enable the tracking
FORMAT: A.B.C.D
FORMAT: slot/port
ip-protocol-number or protocol-type is the type
of protocol to be redirected
FORMAT: 0-255 for IP protocol number, or enter
protocol type
source ip-address or any or host ip-address is
the Source’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
678
Policy-based Routing (PBR)