Filter
Top Products
• a — Page down
• q — Quit
Dell#monitor interface te 3/1
FTOS uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00 Refresh Intvl.: 2s
Interface: Te 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 0 0 Bps 0
Output bytes: 0 0 Bps 0
Input packets: 0 0 pps 0
Output packets: 0 0 pps 0
64B packets: 0 0 pps 0
Over 64B packets: 0 0 pps 0
Over 127B packets: 0 0 pps 0
Over 255B packets: 0 0 pps 0
Over 511B packets: 0 0 pps 0
Over 1023B packets: 0 0 pps 0
Error statistics:
Input underruns: 0 0 pps 0
Input giants: 0 0 pps 0
Input throttles: 0 0 pps 0
Input CRC: 0 0 pps 0
Input IP checksum: 0 0 pps 0
Input overrun: 0 0 pps 0
Output underruns: 0 0 pps 0
Output throttles: 0 0 pps 0
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh interval
q - Quit
q
Dell#
Displaying Traffic Statistics on HiGig Ports
You can verify the buffer usage and queue counters for high-Gigabit Ethernet (HiGig) ports and link
bundles (port channels). The buffer counters supported for front-end ports are extended to HiGig
backplane ports.
You can display the queue statistics and buffer counters for backplane line-card (leaf) and switch fabric
module (SFM - spine) NPU port queues on a Z9500 switch using the show commands described in this
section. Transmit, receive, and drop counters are displayed. Buffer counters include the total number of
cells currently used by all queues on all ports in a port pipe.
The f10-bp-stats.mib is used for gathering statistics about backplane HiGig ports. Line-card NPUs range
from 0 to 3; SFM NPUs range from 0 to 5.
In an NPU unit, port numbering of HiGig ports starts from the last front-end I/O port number used.
Use the show hardware sfm hg-stats and show hardware linecard hg-stats commands to
display traffic statistics about the HiGig links on a line-card or SFM NPU.
422
Interfaces