Filter
Top Products
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop
and the destination port-channel is shut down, the traffic is dropped. However, on the S-Series, the
traffic redirected to the destination port-channel is sometimes switched.
Use the following command inINTERFACE mode to apply a redirect list to an interface. Multiple redirect-
lists can be applied to a redirect-group. It is also possible to create two or more redirect-groups on one
interface for backup purposes.
Command Syntax Command Mode Purpose
ip redirect-group redirect-list-name INTERFACE Apply a redirect list (policy-based routing) to
an interface.
redirect-list-name is the name of a redirect
list to apply to this interface.
FORMAT: up to 16 characters
Delete the redirect list from this interface with the [no] ip
redirect-group command.
In this example, the list “xyz” is applied to the tenGigabitEthernet 4/0 interface.
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-2/0)#ip redirect-group xyz
Dell(conf-if-te-2/0)#
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-1/0)#ip redirect-group test
Dell(conf-if-te-1/0)#ip redirect-group xyz
Dell(conf-if-te-1/0)#show config
!
interface TenGigabitEthernet 1/0
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/0)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are
supported on a single interface. Dell Networking OS has the capability to support multiple groups on an
interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following command in EXEC mode:
Command Syntax Command Mode Purpose
show ip redirect-list redirect-list-name EXEC View the redirect list configuration and
the associated interfaces.
Policy-based Routing (PBR)
681