Filter
Top Products
Marking Egress Packets with a DEI Value
On egress, you can set the DEI value according to a different mapping than ingress.
For ingress information, refer to Honoring the Incoming DEI Value.
To mark egress packets, use the following command.
• Set the DEI value on egress according to the color currently assigned to the packet.
INTERFACE mode
dei mark {green | yellow} {0 | 1}
Example of Viewing DEI-Marking Configuration
To display the DEI-marking configuration, use the show interface dei-mark [interface slot/
port | linecard number port-set number] in EXEC Privilege mode.
Dell#show interface dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
--------------------------------
Te 0/1 Green 0
Te 0/1 Yellow 1
Te 1/9 Yellow 0
Te 1/40 Yellow 0
Dynamic Mode CoS for VLAN Stacking
One of the ways to ensure quality of service for customer VLAN-tagged frames is to use the 802.1p
priority bits in the tag to indicate the level of QoS desired.
When an S-Tag is added to incoming customer frames, the 802.1p bits on the S-Tag may be configured
statically for each customer or derived from the C-Tag using Dynamic Mode CoS. Dynamic Mode CoS
maps the C-Tag 802.1p value to a S-Tag 802.1p value.
Figure 111. Statically and Dynamically Assigned dot1p for VLAN Stacking
When configuring Dynamic Mode CoS, you have two options:
Service Provider Bridging
829