Filter
Top Products
Enabling GVRP Globally
To configure GVRP globally, use the following command.
• Enable GVRP for the entire switch.
CONFIGURATION mode
gvrp enable
Example of Configuring GVRP
Dell(conf)#protocol gvrp
Dell(config-gvrp)#no disable
Dell(config-gvrp)#show config
!
protocol gvrp
no disable
Dell(config-gvrp)#
To inspect the global configuration, use the show gvrp brief command.
Enabling GVRP on a Layer 2 Interface
To enable GVRP on a Layer 2 interface, use the following command.
• Enable GVRP on a Layer 2 interface.
INTERFACE mode
gvrp enable
Example of Enabling GVRP on an Interface
Dell(conf-if-te-1/21)#switchport
Dell(conf-if-te-1/21)#gvrp enable
Dell(conf-if-te-1/21)#no shutdown
Dell(conf-if-te-1/21)#show config
!
interface TenGigabitEthernet 1/21
no ip address
switchport
gvrp enable
no shutdown
To inspect the interface configuration, use the show config command from INTERFACE mode or use
the
show gvrp interface command in EXEC or EXEC Privilege mode.
Configure GVRP Registration
Configure GVRP registration.
There are two GVRP registration modes:
• Fixed Registration Mode — figuring a port in fixed registration mode allows for manual creation and
registration of VLANs, prevents VLAN deregistration, and registers all VLANs known on other ports on
the port. For example, if an interface is statically configured via the CLI to belong to a VLAN, it should
GARP VLAN Registration Protocol (GVRP)
381