Filter
Top Products
sFlow Show Commands
You can display sFlow statistics at the switch, interface, and line card level.
• Displaying Show sFlow Globally
• Displaying Show sFlow on an Interface
• Displaying Show sFlow on a Line Card
Displaying Show sFlow Global
To view sFlow statistics, use the following command.
• Display sFlow configuration information and statistics.
EXEC mode
show sflow
Example of Viewing sFlow Configuration (Global)
The first bold line indicates sFlow is globally enabled. The second bold lines indicate sFlow is enabled on
linecards Te 1/16 and Te 1/17.
Dell#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
Linecard 1 Port set 0 H/W sampling rate 8192
Te 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1
Te 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2
Displaying Show sFlow on an Interface
To view sFlow information on a specific interface, use the following command.
• Display sFlow configuration information and statistics on a specific interface.
EXEC mode
show sflow interface interface-name
Examples of Viewing a sFlow Configuration
The following example shows the show sflow interface command.
Dell#show sflow interface tengigabitethernet 1/16
Te 1/16
Configured sampling rate :8192
Actual sampling rate :8192
Sub-sampling rate :2
Counter polling interval :15
Samples rcvd from h/w :33
Samples dropped for sub-sampling :6
sFlow
839