Filter
Top Products
snmp-server contact text
You may use up to 55 characters.
The default is None.
• (From a Dell Networking system) Identify the physical location of the system (for example, San Jose,
350 Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmp-server location text
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the system manager along with this person’s contact
information (for example, an email address or phone number).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysContact.0 s “contact-info”
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the physical location of the system (for example, San Jose, 350
Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysLocation.0 s “location-info”
You may use up to 55 characters.
The default is None.
Subscribing to Managed Object Value Updates using
SNMP
By default, the system displays some unsolicited SNMP messages (traps) upon certain events and
conditions.
You can also configure the system to send the traps to a management station. Traps cannot be saved on
the system.
The following sets of traps are supported:
• RFC 1157-defined traps — coldStart, warmStart, linkDown, linkUp, authenticationFailure, and
egpNeighbborLoss.
• Dell Networking enterpriseSpecific environment traps — fan, supply, and temperature.
• Dell Networking enterpriseSpecific protocol traps — bgp, ecfm, stp, and xstp.
To configure the system to send SNMP notifications, use the following commands.
1. Configure the Dell Networking system to send notifications to an SNMP server.
CONFIGURATION mode
Simple Network Management Protocol (SNMP)
849