Filter
Top Products
OSPF 0 0 0
RIP 0 0 0
VRRP 0 0 0
ICMP 0 0 0
IGMP 0 0 0
PIM 0 0 0
MSDP 0 0 0
BFD ON PHYSICAL PORTS 0 0 0
BFD ON LOGICAL PORTS 0 0 0
802.1x 0 0 0
iSCSI 0 0 0
DHCP RELAY 0 0 0
DHCP 0 0 0
NTP 0 0 0
FTP 0 0 0
TELNET 0 0 0
SSH 0 0 0
VLT CTRL 0 0 0
VLT IPM PDU 0 0 0
VLT TTL1 0 0 0
HYPERPULL 0 0 0
OPENFLOW 0 0 0
FEFD 0 0 0
TRACEFLOW 0 0 0
FCoE 0 0 0
SFLOW 0 0 0
L3 LOCAL TERMINATED 0 0 0
L3 UNKNOWN/UNRESOLVED ARP 0 0 0
L2 DST HIT/BROADCAST 0 0 0
MULTICAST CATCH ALL 0 0 0
v6 MULTICAST CATCH ALL 12600 12600 0
L3 HEADER ERROR/TTL0 0 0 0
IP OPTION/TTL1 0 0 0
L3 MTU FAIL 0 0 0
SOURCE MISS 0 0 0
STATION MOVE 0 0 0
TX ENTRY 887040 887040 0
DROP ENTRY 0 0 0
To clear the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or line
card and port set level, use the clear control-traffic protocol [cp—switch | linecard {0–
2} portset {0–3}] counters
command; for example:
Dell#clear control-traffic protocol linecard 1 portset 2 counters
Dell#
Dell#clear control-traffic protocol cp-switch counters
Dell#
Viewing Per-Queue CoPP Counters
To view per-queue counters of CoPP rate-limited traffic, use the show control-traffic queue
{all | queue-id queue-number} counters command.
The range of queue-number values is from 0 to 23. The twenty-four control–plane queues are divided
into groups of eight queues for the Route Processor, Control Processor, and line-card CPUs as follows:
• Queues 0 to 7 process packets destined to the Control Processor CPU .
• Queues 8 to 15 process packets destined to the Route Processor CPU.
• Queues 16 to 23 process packets destined to the line card CPU.
Control Plane Policing (CoPP)
239