Filter
Top Products
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
EcfmAcl : 0
nlbclusteracl: 0
Openflow : 0
-- linecard 2 --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
EcfmAcl : 0
nlbclusteracl: 0
Openflow : 0
The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other
profile allocations can use either even or odd numbered ranges.
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
1. Select a cam-acl action.
CONFIGURATION mode
cam-acl [default | l2acl]
NOTE: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate
space for the ACLs and QoS regions.
2. Enter the number of FP blocks for each region.
EXEC Privilege mode
l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number,
l2pt number ipmacacl number ecfmacl number nlbclusteracl number [vman-qos |
vman-dual-qos number
NOTE: If the allocation values are not entered for the CAM regions, the value is 0.
3. Verify that the new settings will be written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4. Reload the system.
Content Addressable Memory (CAM)
217