Filter
Top Products
snmp-server group groupname {oid-tree} auth read name write name
• Configure an SNMPv3 view.
CONFIGURATION mode
snmp-server view view-name 3 noauth {included | excluded}
NOTE: To give a user read and write privileges, repeat this step for each privilege type.
• Configure an SNMP group (with password or privacy privileges).
CONFIGURATION mode
snmp-server group group-name {oid-tree} priv read name write name
• Configure the user with a secure authorization password and privacy password.
CONFIGURATION mode
snmp-server user name group-name {oid-tree} auth md5 auth-password priv des56
priv password
• Configure an SNMPv3 view.
CONFIGURATION mode
snmp-server view view-name oid-tree {included | excluded}
Select a User-based Security Type
Dell(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 ?
auth Use the SNMPv3 authNoPriv Security Level
noauth Use the SNMPv3 noAuthNoPriv Security Level
priv Use the SNMPv3 authPriv Security Level
Dell(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 noauth ?
WORD SNMPv3 user name
Reading Managed Object Values
You may only retrieve (read) managed object values if your management station is a member of the same
community as the SNMP agent.
Dell Networking supports RFC 4001, Textual Conventions for Internet Work Addresses that defines values
representing a type of internet address. These values display for ipAddressTable objects using the
snmpwalk command.
There are several UNIX SNMP commands that read data.
• Read the value of a single managed object.
snmpget -v version -c community agent-ip {identifier.instance |
descriptor.instance}
• Read the value of the managed object directly below the specified object.
snmpgetnext -v version -c community agent-ip {identifier.instance |
descriptor.instance}
• Read the value of many objects at once.
snmpwalk -v version -c community agent-ip {identifier.instance |
descriptor.instance}
Simple Network Management Protocol (SNMP)
847