Filter
Top Products
Level 7 VLAN 1000
entity
Enable entity change traps
Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1487406) 4:07:54.06,
SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,
SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 4
Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1488564) 4:08:05.64,
SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,
SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 5
Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1489064) 4:08:10.64,
SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,
SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 6
Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1489568)
4:08:15.68,SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,
SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 7
<cr>
SNMP Copy Config Command Completed
%SYSTEM-P:CP %SNMP-4-RMON_RISING_THRESHOLD: RMON rising threshold alarm from
SNMP OID <oid>
%SYSTEM-P:CP %SNMP-4-RMON_FALLING_THRESHOLD: RMON falling threshold alarm from
SNMP OID <oid>
%SYSTEM-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: RMON high-capacity rising
threshold
alarm from SNMP OID <oid>
Copy Configuration Files Using SNMP
To do the following, use SNMP from a remote client.
• copy the running-config file to the startup-config file
• copy configuration files from the Dell Networking system to a server
• copy configuration files from a server to the Dell Networking system
You can perform all of these tasks using IPv4 or IPv6 addresses. The examples in this section use IPv4
addresses; however, you can substitute IPv6 addresses for the IPv4 addresses in all of the examples.
The following table lists the relevant MIBs for these functions are.
Table 62. MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Object Values Description
copySrcFileType .
1.3.6.1.4.1.6027.3.5.1.1.1.
1.2
1 = Dell Networking OS
file
2 = running-config
3 = startup-config
Specifies the type of file
to copy from. The range
is:
• If copySrcFileType is
running-config or
startup-config, the
default
copySrcFileLocation
is flash.
• If copySrcFileType is
a binary file, you
must also specify
copySrcFileLocation
852
Simple Network Management Protocol (SNMP)