Filter
Top Products
To enable FCoE transit on the switch and configure the FCoE transit parameters on ports, follow these
steps.
1. Configure FCoE.
FCoE configuration:
copy flash:/ CONFIG_TEMPLATE/ FCoE_DCB_Config running-config
The configuration files are stored in the flash memory in the CONFIG_TEMPLATE file.
NOTE: DCB/DCBx is enabled when either of these configurations is applied.
2. Save the configuration on the switch.
EXEC Privilege mode.
write memory
3. Reload the switch to enable the configuration.
EXEC Privilege mode.
reload
After the switch is reloaded, DCB/DCBx is enabled.
4. Enable the FCoE transit feature on a switch.
CONFIGURATION mode.
feature fip-snooping
5. Enable FIP snooping on all VLANs or on a specified VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
6. Configure the port for bridge-to-FCF links.
INTERFACE mode or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE: To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a
command; for example,
no feature fip-snooping or no fip-snooping enable.
352
FCoE Transit