Dell 9.7(0.0) Plumbing Product User Manual


  Open as PDF
of 1039
 
Priority group range is from 0 to 7. All priorities that map to the same queue must be in the same
priority group.
Leave a space between each priority group number. For example: priority-pgid 0 0 0 1 2 4 4 4 in
which priority group 0 maps to dot1p priorities 0, 1, and 2; priority group 1 maps to dot1p priority 3;
priority group 2 maps to dot1p priority 4; priority group 4 maps to dot1p priorities 5, 6, and 7.
Dell Networking OS Behavior: As soon as you apply a DCB policy with PFC enabled on an interface,
DCBx starts exchanging information with PFC-enabled peers. The IEEE802.1Qbb, CEE, and CIN versions
of PFC Type, Length, Value (TLV) are supported. DCBx also validates PFC configurations that are received
in TLVs from peer devices.
NOTE: You cannot enable PFC and link-level flow control at the same time on an interface.
Dell Networking OS does not support MACsec Bypass Capability (MBC).
Configuring Lossless Queues
DCB also supports the manual configuration of lossless queues on an interface when PFC mode is turned
off.
Prerequisite: A DCB with PFC configuration is applied to the interface with the following conditions:
PFC mode is off (no pfc mode on).
No PFC priority classes are configured (no pfc priority priority-range).
The configuration of no-drop queues provides flexibility for ports on which PFC is not needed but
lossless traffic should egress from the interface.
Lossless traffic egresses out the no-drop queues. Ingress dot1p traffic from PFC-enabled interfaces is
automatically mapped to the no-drop egress queues.
1. Enter INTERFACE Configuration mode.
CONFIGURATION mode
interface type slot/port
2. Configure the port queues that will still function as no-drop queues for lossless traffic.
INTERFACE mode
pfc no-drop queues queue-range
For the dot1p-queue assignments, refer to the dot1p Priority-Queue Assignment table.
The maximum number of lossless queues globally supported on the switch is two.
The range is from 0 to 3. Separate the queue values with a comma; specify a priority range with a
dash; for example, pfc no-drop queues 1,3 or pfc no-drop queues 2-3.
The default: No lossless queues are configured.
NOTE: Dell Networking OS Behavior: By default, no lossless queues are configured on a port.
A limit of two lossless queues is supported on a port. If the amount of priority traffic that you configure to
be paused exceeds the two lossless queues, an error message displays.
In Z9500, any pfc-dot1p priorities configured on a given interface need not be the same across the
system. In other words, lossless queue limit is applicable on a per-port level and not on the global-config
Data Center Bridging (DCB)
255