Filter
Top Products
TenGigabitEthernet 0/8 unassigned YES Manual up up
TenGigabitEthernet 0/9 unassigned YES Manual up up
Rainier(conf)# do show version
Dell Real Time Operating System Software
Dell Operating System Version: 2.0
Dell Application Software Version: 9-5
Copyright (c) 1999-2014 by Dell Inc. All Rights Reserved.
Build Time: Wed Jul 2 11:24:04 2014
Build Path: /sites/eqx/work/swbuild01_1/build16/MERCED-MR-9-5-0/SW/SRC
Dell Networking OS uptime is 2 hour(s), 20 minute(s)
System image file is "rith-rainier"
System Type: Z9500
Control Processor: Intel Centerton with 3 Gbytes (3203928064 bytes) of memory,
cores(s) 2.
16G bytes of boot flash memory.
1 36-port TE/FG (ZC)
2 48-port TE/FG (ZC)
520 Ten GigabitEthernet/IEEE 802.3 interface(s)
2 Forty GigabitEthernet/IEEE 802.3 interface(s)
Rainier(conf)# do show running-config interface tengigabitethernet 0/0
!
interface TenGigabitEthernet 0/0
no ip address
no shutdown
Undoing Commands
When you enter a command, the command line is added to the running configuration file (running-
config).
To disable a command and remove it from the running-config, enter the no command, then the original
command. For example, to delete an IP address configured on an interface, use the
no ip address
ip-address command.
NOTE: Use the help or ? command as described in Obtaining Help.
Example of Viewing Disabled Commands
Dell(conf)#interface tengigabitethernet 4/17
Dell(conf-if-te-4/17)#ip address 192.168.10.1/24
Dell(conf-if-te-4/17)#show config
!
interface TenGigabitEthernet 4/17
ip address 192.168.10.1/24
no shutdown
Dell(conf-if-te-4/17)#no ip address
Dell(conf-if-te-4/17)#show config
!
interface TenGigabitEthernet 4/17
no ip address
no shutdown
Layer 2 protocols are disabled by default. To enable Layer 2 protocols, use the no disable command.
For example, in PROTOCOL SPANNING TREE mode, enter no disable to enable Spanning Tree.
Configuration Fundamentals
39