Filter
Top Products
Field Description
priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for
DCBx exchange, the Willing bit received in ETS
TLVs from the remote peer is included.
Local Parameters ETS configuration on local port, including Admin
mode (enabled when a valid TLV is received from a
peer), priority groups, assigned dot1p priorities, and
bandwidth allocation.
Operational status (local port) Port state for current operational ETS
configuration:
• Init: Local ETS configuration parameters were
exchanged with peer.
• Recommend: Remote ETS configuration
parameters were received from peer.
• Internally propagated: ETS configuration
parameters were received from configuration
source.
ETS DCBx Oper status Operational status of ETS configuration on local
port: match or mismatch.
State Machine Type Type of state machine used for DCBx exchanges of
ETS parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Conf TLV Tx Status Status of ETS Configuration TLV advertisements:
enabled or disabled.
ETS TLV Statistic: Input Conf TLV pkts Number of ETS Configuration TLVs received.
ETS TLV Statistic: Output Conf TLV pkts Number of ETS Configuration TLVs transmitted.
ETS TLV Statistic: Error Conf TLV pkts Number of ETS Error Configuration TLVs received.
The following example shows the show linecard 2 port-set 0 backplane all pfc details
command.
Dell#show linecard 2 port-set 0 backplane all pfc details
2 port-set 0 backplane all
Admin mode is On
Admin is enabled, Priority list is 3
Local is enabled, Priority list is 3
Link Delay 65535 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
The following example shows the show linecard 2 port-set 0 backplane all ets details
command.
Dell#sh linecard 2 port-set 0 backplane all ets details
linecard 2 port-set 0 backplane all
Max Supported PG is 4
Data Center Bridging (DCB)
277