Filter
Top Products
mode
Dell(conf)#service-pool wred green pool0 thresh-1 pool1 thresh-2
Dell(conf)#service-pool wred yellow pool0 thresh-3 pool1 thresh-4
Dell(conf)#service-pool wred weight pool0 11 pool1 4
5. Enable ECN marking on specific queues on backplane ports with a service class.
CONFIGURATION mode
Dell(conf)#service-class wred ecn 0, 3-5, 7 backplane
Pre-Calculating Available QoS CAM Space
Pre-calculating available QoS CAM space allows you to measure the number of CAM entries a policy-
map consumes.
This feature allows you to avoid applying a policy-map on an interface that requires more CAM entries
than are available and receive a CAM full error message (shown in the following example). The partial
policy-map configuration might cause unintentional system behavior.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (Te 12/20) entries on portpipe 1 for linecard 12
%EX2YD:12 %DIFFSERV-2-
DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for
class 5 (Te 12/
22) entries on portpipe 1 for linecard 12
Use the test cam-usage command to verify that there are enough available CAM entries before
applying a policy-map to an interface so that you avoid exceeding the QoS CAM space and partial
configurations. This command measures the size of the specified policy-map and compares it to the
available CAM space in a partition for a specified port-pipe.
Test the policy-map size against the CAM space for a specific port-pipe or all port-pipes using these
commands:
• test cam-usage service-policy input policy-map linecard {0–2} number port-set
number
• test cam-usage service-policy input policy-map linecard {0–2} all
The output of this command, shown in the following example, displays:
• The estimated number of CAM entries the policy-map will consume.
• Whether or not the policy-map can be applied.
• The number of interfaces in a port-pipe to which the policy-map can be applied.
Specifically:
• Available CAM — the available number of CAM entries in the specified CAM partition for the specified
line-card port pipe.
• Estimated CAM — the estimated number of CAM entries that the policy will consume when it is
applied to an interface.
• Status — indicates whether the specified policy-map can be completely applied to an interface in the
port-pipe.
Quality of Service (QoS)
747