Filter
Top Products
Chapter 4 First Light 59
13. For WinSpec Applications: Click on the ROI Setup tab and select Imaging Mode. See
Figure 4-12.
Figure 4-12: Typical Experiment Setup Dialog: ROI Setup Tab
14.
Click OK to save the configuration settings and dismiss the Experiment Setup dialog.
4.6.4 Initial Data Acquisition
Perform the following procedure to begin initial data acquisition for a test image:
NOTE:
When using a C-mount lens, a PI-MAX4 will typically focus
on an object at distance of approximately 9 inches [22.86 cm.]
1. Verify that room or ambient lighting is subdued.
2. Turn on the PI-MAX4 I.I.T.
NOTE:
The PI-MAX4 overload alarm may sound briefly and then
stop. This is normal and is not a cause for concern. However, if
the alarm sounds repetitively, even with no light entering the
lens, something is wrong. Turn off the power and contact the
factory for guidance.
4411-0137_0015