Filter
Top Products
Chapter 3 System Setup 39
3.5.2 Spectroscopy Applications
The camera must be properly mounted to the spectrograph to achieve the highest resolution.
In the correct orientation, the text on the back of the camera should be right side up. Take
care not to block the ventilation openings.
REFERENCES:
For additional information, refer to:
• Quick Start: Mounting a PI-MAX3 or PI-MAX4 (3.60
3-hole Slotted) to an Acton SpectraPro Series
Spectrograph;
• Quick Start: Princeton Instruments Camera with Slotted
Flange to an IsoPlane SCT-320 Spectrograph;
• Instructions provided with the system;
• Appendix F, Spectrograph Mount Information, on
page 285.
3.6 Application Software Installation
This section provides detailed procedures for the installation of supported application
software.
3.6.1 WinX Applications
This section provides the installation procedure for WinX application software.
NOTES:
1. Install the GigE Adapter card BEFORE installing the
WinView/32 or WinSpec/32 application software.
2. The interface cable should remain disconnected from the
camera until after WinView/32 or WinSpec/32 (version
2.5.25 or higher) has been successfully installed.
Perform the following procedure to install WinX on the host computer:
1. Insert the WinView/32 or WinSpec/32 software installation CD into the CD drive on the
host computer. The installation program will automatically launch.
2. When the Select Installation Type dialog is displayed, select the desired type of
installation.
•Typical installs all required drivers and the most commonly installed program
files;
• Complete installs all available application drivers and features;
•Custom is used to select specific features and drivers for installation, as well as
specifying a custom installation directory. This is only recommended for use by
advanced users.
Figure 3-1 illustrates a typical WinView/32 Setup dialog.