Princeton 4411-0139 Home Security System User Manual


  Open as PDF
of 318
 
Chapter 10 WinX and Dual Image Feature 169
Figure 10-12:Timing Diagram: DIF Operation, Dual Trigger
Perform the following procedure to configure a dual trigger DIF experiment:
1. The PI-MAX4 camera must be aligned and focused on the area of interest for this
experiment. This is best accomplished while the PI-MAX4 is operating in Interline mode
(i.e., before switching to DIF mode.)
REFERENCES:
Refer to Chapter 4, First Light, for information about the initial
focusing of the camera.
Verify that the
Phosphor Decay Time is appropriate to the phosphor used by the camera.
his field is located on the
Setup —> Hardware Setup —> Controller/Camera tab. See
Figure 10-13.
Figure 10-13:WinX Hardware Setup Dialog: Controller/Camera Tab
' ,QLWLDO*DWH'HOD\XV ' 3XOVH*DWH'HOD\PLQGHOD\RIFDPHUDaQV
3' 3KRVSKRU'HFD\7LPH
W1 3XOVH*DWH:LGWK
: 3XOVH*DWH:LGWK
D1 W1 D2 W2PD PD
75,**(5
,0$*(6
FIRST FRAME SECOND FRAME
6+,)7%(+,1'
0$6.
77 7LPHEHWZHHQ7ULJJHUV'Z3'
77
4411-0137_0097
4411-0137_0092
 previous next