Filter
Top Products
Chapter 13 PI-MAX4: 1024i-RF and RF Modulation 191
5. Use the hyperlinks at the top of the expanded panel to make any changes to the
intensifier settings, trigger settings, phosphor decay delay time, number of frames, and
readout mode.
6. If using camera-generated internal triggers for RF modulation acquisition, enter the
desired
Internal Trigger Frequency.
7. To have trigger output from the SyncMASTER1 and SyncMASTER2 connectors on the
AUX I/O cable, click on the
SyncMASTER ON button. When SyncMASTER is
enabled, the output of the
SyncMASTER1 connector will be at the Internal Trigger
Frequency
. The SyncMASTER2 output will be at the same frequency but can be
delayed. The available range for this delay is 0 to 6553500 ns in 100 ns increments.
NOTE:
The blue SyncMASTER1 and black SyncMASTER2 cables
are used to differentiate these output signals when they are
shown on the SuperSYNCHRO timing diagram.
8. Perform the following procedure to edit/create the custom Phase Modulation table:
a. Click on the Edit Phase Modulations… button to display the Edit Custom Phase
Modulations
dialog similar to that shown in Figure 13-5.
Figure 13-5: Typical Edit Custom Phase Modulations Window
4411-0137_0161