Filter
Top Products
104 PI-MAX
®
4 System Manual Issue 4
Figure 6-4: Block/Timing Diagram: Swept Gate Experiment
2.
Turn on all equipment and launch LightField.
3. Open the Sensor expander and click on the Sensor Cleaning button. See Figure 6-5.
Figure 6-5: Typical Sensor Cleaning Fly-out Pane
a. If one or more orange reset button are displayed on the fly-out pane, click on them
to reset to their default values.
b. Configure the camera’s temperature, in degrees Celsius, by configuring the Target
Setpoint
field on the Sensor expander.
Trigger In
*
* Level changes for T0 depend on the pulse sequence(s) defined by the user.
PI-MAX4
Photodiode
~12 ns
Delay is programmable.
Aux Out
GigE
96-264
4411-0137_0050
4411-0137_0070