Filter
Top Products
198 PI-MAX
®
4 System Manual Issue 4
4. Perform the following procedure to sort SPE frames by phase after each acquisition:
a. Click on the Add-ins tab and locate the Phase Modulation Sorting expander. If
necessary, click on the to expand it. See Figure 13-11.
Figure 13-11:Typical Phase Modulation Sorting Add-in
b.
Check the box next to Sort after each acquisition, and select the desired sort order
from the pull-down list (i.e.,
Ascending or Descending.)
c. If desired, check the box next to Sort as Complete Cycle (0° to 0°.) When checked,
alternate 0 degree Phases will be treated as 360 degree points.
d. Perform the experiment as usual, and two SPE files are saved for each acquisition.
For example, the two files from an experiment could be named:
• 2013 August 20 15_10_20.spe
This is the set of frames that have been sorted by Phase Modulation.
• 2013 August 20 15_10_20-unsorted.spe
This is the original set of frames.
5. Perform the following procedure to sort SPE frames from a prior experiment:
a. Within LightField, click on the Data tab.
b. Locate and click on the Sort Phases… add-in button within the Data Toolbar. See
Figure 13-12.
Figure 13-12:Typical Phase Modulation Sorting Add-in Button: Data Toolbar
The Sort Phases dialog is displayed, similar to that shown in Figure 13-13.
4411-0137_0167
COLLAPSED
EXPANDED/OPEN
4411-0137_0168