Filter
Top Products
Chapter 7 WinX and Gated Operation 131
11. After the spectrograph and been installed and configured, move the grating to the
desired wavelength. See Figure 7-7.
Figure 7-7: Typical Move Spectrograph Dialog
12.
Verify that the camera is operating and is properly focused by running it in Internal
Trigger
mode.
Perform the following procedure to run in Internal Trigger mode to verify camera focus:
a. From the pull-down menu, select Experiment Setup. If necessary, click on the Main
tab. See Figure 7-8.
Figure 7-8: Typical Experiment Setup Dialog: Main Tab
4411-0137_0052
4411-0137_0013