Filter
Top Products
Appendix C WinX/LightField Cross Reference 277
C.2 LightField to WinX
Refer to Table C-2 for a list of LightField terms and their corresponding WinX terms.
Table C-2: LightField-to-WinX Cross Reference (Sheet 1 of 2)
LightField Term WinX Term
Active Area: Bottom Margin Post-Dummy Rows Parallel to Shift Register
Active Area: Left Margin Pre-Dummy Shift Register Columns
Active Area: Right Margin Post-Dummy Shift Register Columns
Active Area: Top Margin F.T. Dummies or Frame Transfer Dummies
Active Area: Top Margin Pre-Dummy Rows Parallel to Shift Register
Active Height Active Rows Parallel to Shift Register
Active Width Active Shift Register Columns
Always Closed (Shutter) Disabled Closed (Shutter)
Always Open (Shutter) Disabled Open (Shutter)
Analog Gain Controller Gain
Bit Depth ADC Resolution
Clean Cycle Height Number of Strips per Clean
Clean Serial Register Skip Serial Register Clean (deselected)
Clean Until Trigger Continuous Cleans
Closing Delay Shutter Close Compensation Time
Custom Sensor Custom Chip
Custom Timing Custom Timing
Final Section Count Number of Blocks
Final Section Height Minimum Block Size
No Response Free Run
Normal (Shutter) Normal Shutter
Number of Clean Cycles Number of Cleans
Open Before Trigger (Shutter) PreOpen (Shutter)
Opening Delay Shutter Open Compensation Time
Output Signal Logic Out
Output Signal: Always High Logic Out: Logic 1
Output Signal: Always Low Logic Out: Logic 0
Output Signal: Busy Logic Out: Not Ready
Output Signal: Not Reading Out Logic Out: Not Scan
Output Signal: Shutter Open Logic Out: Shutter