Filter
Top Products
Chapter 7 WinX and Gated Operation 143
Once the equipment has been set up, default values for Cleans/Skips are configured. See
Figure 7-26.
NOTE:
If the CCD has to wait more than a few seconds for an external
trigger, it is advisable to increase the number of cleans.
Figure 7-26: Hardware Setup Dialog: Cleans/Skips Tab
The sequence of operations is similar to that for Sequential experiments. After focusing the
camera on the fluorescing sample, the camera is configured for
Gate mode and an
appropriate
Gain is configured. See Figure 7-27.
4411-0137_0065