Filter
Top Products
44 PI-MAX
®
4 System Manual Issue 4
3.8 Configure Default Camera System Parameters
This section describes the initial configuration of default camera parameters.
3.8.1 WinX (Versions 2.5.25.X or higher)
Perform the following procedure to configure default WinX system parameters:
1. Make sure the PI-MAX4 is connected to the host computer and that its power supply is
turned ON.
2. Launch the WinX application.
• The Camera Detection Wizard will automatically run if this is the first time a
Princeton Instruments WinX application (WinView/32, WinSpec/32, or WinXTest/
32) has been installed with a supported camera.
• If simply installing a new camera type, click on the Launch Camera Detection
Wizard…
button on the Controller/CCD tab to launch the wizard.
3. When the Welcome dialog is displayed, the check box should remain unchecked. Click
Next.
See Figure 3-4.
Figure 3-4: Typical WinX Camera Detection Wizard Dialog
4.
Follow the on-screen prompts to perform the initial hardware setup.
The wizard automatically populates Hardware configuration parameters with default
values and provides the opportunity to acquire a test image to verify the system is
working properly.
NOTE:
For step-by-step procedures describing basic system operation
within WinX, refer to Section 4.6, WinX First Light
Instructions, on page 55.
4411-0137_0008