Filter
Top Products
2 - 11
Chapter 2 System Configuration
2.5 Restrictions by the SERIAL No. and version
There are restrictions in the function that can be used by the SERIAL No. of the Simple
Motion module and the version of GX Works2.
The combination of each version and function are shown below.
Function
QD77MS2/QD77MS4 QD77MS16
Reference
First five digits of
SERIAL No.
(Note-1)
GX Works2
First five digits of
SERIAL No.
(Note-1)
GX Works2
Inverter FR-A700 series 14062 or later 1.492N or later 14062 or later 1.492N or later Appendix 6.3
Driver communication function
15042 or later 1.492N or later 15042 or later 1.492N or later
Section 14.9
Synchronous encoder via servo
amplifier
(Note-2)
Mark detection function
(Changes latch data range upper
limit value/lower limit value during
mark detection.)
Section 14.10
External command signal
compensation valid/invalid setting
Section 5.2.7
Operation cycle setting for
QD77MS2/QD77MS4
15062 or later 1.493P or later — —
Section 5.2.7
Section 5.6.1
Servo driver (VCII series)
manufactured by Nikki Denso Co.,
Ltd. (SSCNET
/H)
16012 or later 1.507D or later 16012 or later 1.507D or later Appendix 6.1
MR-JE-B 16102 or later 1.525X or later 16102 or later 1.525X or later Appendix 6.3
Hot line forced stop function 16102 or later — 16102 or later — Section 14.15
(Note-1): The serial number can be checked on the "Product Information List" screen in GX Works2.
(Note-2): "MELSEC-Q/L QD77MS/QD77GF/LD77MS/LD77MH Simple Motion Module User’s Manual (Synchronous Control)"