Filter
Top Products
5 - 168
Chapter 5 Data Used for Positioning Control
Setting item Setting details
[Cd.7] M code OFF request
The M code ON signal turns OFF.
Fetch cycle: Operation cycle
[Cd.8] External command valid
Validates or invalidates external command signals.
Fetch cycle: At request by external command signal
[Cd.9] New current value
When changing the "current feed value" using the start No. "9003", use this data
item to specify a new feed value.
Set a value within the following range:
[Pr.1] Unit
setting
mm
(
10
-1
µm)
inch
(
10
-5
inch)
degree
(
10
-5
degree)
PLS
(PLS)
Setting range
-2147483648
to
2147483647
-2147483648
to
2147483647
0 to 35999999
-2147483648
to
2147483647
Fetch cycle: At change request
[Cd.10] New acceleration time value
When changing the acceleration time during a speed change, use this data item
to specify a new acceleration time.
[Cd.10] setting range (unit)
0 to 8388608 (ms)
Fetch cycle: At change request
[Cd.11] New deceleration time value
When changing the deceleration time during a speed change, use this data item
to specify a new deceleration time.
[Cd.11] setting range (unit)
0 to 8388608 (ms)
Fetch cycle: At change request